Cleaning The Oven Door; Changing The Oven Light Bulb - Kuppersbusch CM6330 Instrucciones De Instalación

4. Fix the front fastening nut (C) in the front
notch of the support. Figure 11.
5. Secure the support with the nut (D) and
turn until it is fully adjusted (E) Figure 11.
Failure to secure tightly the support with
the nuts may lead to overheating and
damages.

CLEANING THE OVEN DOOR

Dismantling/assembling the interior glass
of the door
If dismantling the glass panes with the
door fitted in the oven, always do it with
the hinge in the locked position. If not,
the door will close and the unmounted
glass panes could break and cause
injury.
Depending on the model, your oven may
have 1 or 3 panes of glass. Follow the
instructions for the type of door your oven
has.
1. Using your fingers, press the buttons
located at the top of both sides of the
oven door. Figure 12.
2. Keep them pressed and pull on the
plastic seal above the door. Figure 13.
3. Remove the glass panes from the door.
Clean them with a glass cleaner or soap
and water and a soft cloth.
Pay attention to the order and position of
the glass panes when removing them as
they must be reassembled in the same
order and position when you have
finished cleaning them.
4. Once clean, insert pane no. 3 into the
same position so that the TERMOGLASS
indication printed on it is visible as
shown in Figure 14.
5. Reattach the top seal of the door, making
sure that the side tabs fit into their
housings.
Never switch the oven on if any of the
glass panes on the door are missing.

CHANGING THE OVEN LIGHT BULB

Make sure the
disconnected from the mains before
changing the bulb.
The replacement
temperatures up to 300 ºC. You can order
them from the Technical Assistance Service
Department.
Changing the upper bulb
To substitute the light bulb, proceed as
follows:
1. Disconnect the oven from the power
supply. Take the plug out of the socket
2. Loose and remove the glass light cover
(1).
3. Remove the bulb (2). Warning! The bulb
may be very hot.
4. Fit a new G9 230V / 25W bulb. Warning!
Do not touch the light bulb surface
directly with your fingers because you
may damage the bulb. Follow the lamp
5. Tighten the glass light cover into place
(1).
6. Connect the oven again to the power
supply.
english
oven has been
bulb must withstand
27