Setting Up Your Shelf System; Preparing The Remote Control - Insignia NS-A1111 Guia Del Usuario

NS-A1111_final_translationDTP.fm Page 6 Friday, February 17, 2006 12:09 PM
Control Symbol Description
Tuning (down) button
TIMER button
Volume +/- buttons
Disc skip button
Tuning (up) button
Play/pause button
Skip forward/preset+
button
Repeat button
Band button
Function button
Display
Band
Clock
AM/PM
Clock/CD
track/
broadcast
station
Indicator Description
Band Displays FM or AM radio band.
Clock AM/PM Indicates that the time is AM or PM.
Clock/CD track/ • In clock mode, displays the time.
broadcast station • In CD mode, displays the track
• In broadcast station mode,
MEMORY Displays when the track being played is
stored in memory.
STEREO Indicates that the FM signal is playing in
stereo.
REPEAT mode Displays when the repeat feature is in
use.
Radio frequency Shows whether the radio frequency is
megahertz or kilohertz.
6
Press to adjust radio setting
from a higher to lower
frequency.
Press to set a timer alarm.
Press to adjust the volume.
Press to skip playing an
entire disc loaded in the CD
changer.
Press to adjust radio setting
from a lower to higher
frequency.
Press to start or resume
playing a disc.
Press to pause playback of
disc.
Press to start, pause, or
resume playing a disc.
Press to replay a track.
Press to switch between AM
and FM radio bands
Press to switch between CD,
tuner, and aux in.
STEREO
MEMORY
Repeat
mode
Radio
frequency
number.
displays the station number.
www.insignia-products.com
Insignia NS-A1111 5-CD Shelf System
Setting up your shelf
system

Preparing the remote control

Installing remote control batteries
I
Warning
Do not throw the batteries into fire. Dispose of used
batteries as hazardous waste.
I
Caution
Do not drop or disassemble the remote control. Do not
get the remote control wet.
To install batteries in the remote control:
1 Remove the battery cover.
2 Insert one CR2025 (3-volt) battery into the
battery compartment. Make sure that the +/–
symbols on the battery match the +/– marks
inside the battery compartment.
3 Replace the battery cover.
4 Remove the plastic tab covering the remote
control sensor.
5 Point the remote control at the remote sensor
on the shelf system. The effective distance
for remote operation is about 16 feet (5
meters).
Note
When using the remote control and you are
required to move closer to the stereo for the
remote control to operate, replace the battery. The
remote control may not operate correctly if direct
sunlight or the light of a high-frequency fluorescent
lamp enters the remote control light sensor. In this
case, change the system installation position to
prevent the problem.
Note
When the remote control will not be used for a long
period of time or when the batteries are worn out,
remove the batteries to prevent leakage.