Using Your Shelf System - Insignia NS-A1111 Guia Del Usuario

NS-A1111_final_translationDTP.fm Page 7 Friday, February 17, 2006 12:09 PM
Insignia NS-A1111 5-CD Shelf System
Connecting speakers to the shelf system
To connect the speakers:
1 Position the speakers supplied with the shelf
system to the right and left of the shelf
system.
Caution
Connecting speakers other than the speakers
provided with the shelf system may damage the
shelf system.
2 Connect the wires from the speakers to the
amplifier speaker connectors.
Connecting power to the shelf system
Note
Before operating the shelf system in a new area for the
first time, you must check that the operating voltage of
your shelf system is identical to the voltage of your
local power supply. This shelf system is to be operated
only at the power source voltage printed on the back
panel. Disconnect from the power outlet when not in
use for a long period of time.
To connect the power cord:
1 Make sure that the speakers are properly
connected and that the ON/OFF button is set
to OFF.
2 Connect the AC power cord to an AC outlet.
Connecting the antenna
To connect the antenna:
1 Fully unwind the FM wire antenna. Extend
the antenna and move it to determine the
best sound reception.
Note
Do not connect the shelf system's FM antenna to
an outside antenna.
2 Connect the provided AM loop antenna to the
AM LOOP ANTENNA snap terminals on the
back of the shelf system, then move it to
determine the best sound reception.
Connecting external equipment
You can connect external audio systems to the
Right
shelf system.
speaker
box
To connect external equipment:
Left
speaker
1 Make sure that the power on the shelf system
box
is off.
2 Plug the jack from the external equipment
into the aux in jack (with the music note
Amplifier
symbol) on the front panel.
speaker
conectors
Connecting headphones
To connect the headphones:
1 Turn down the volume on the shelf system.
AC power
cord
2 Plug headphones with a 3.5 mm stereo mini
plug into the headphone jack.
Note
When the headphones are connected, the
speakers on the shelf system are automatically
disabled.

Using your shelf system

Turning the shelf system on and off
The display changes according to the button
pressed or feature selected.
To turn the shelf system on and off:
1 When the shelf system is off, press the ON/
OFF button on the shelf system once to turn
it on. The display shows d1 and turns on the
display backlight.
2 When the shelf system is on, press the ON/
OFF button on the shelf system once to turn
it off. The display backlight goes out.
When the shelf system is turned off, the clock
still shows on the display without a backlight.
This is called the standby mode.
Note
Disconnect the power cord when the unit is not
going to be used for a long time.
Listening to external equipment
To listen to external equipment:
1 Press the ON/OFF button on the shelf
system once to turn it on.
2 Press the Function button on the front panel
to Aux, indicated by a music note symbol on
the display.
3 Turn on the external equipment.
Note
If the external equipment is a television and this
shelf system is close to the TV, you may
experience interference if the tuner function is
selected while the TV is on.
www.insignia-products.com
7