Össur Flex Instrucciones De Uso página 7

2
Lift stop cover and insert desired extension stop into top half of
groove [Figure 10].
3
Make sure notch in extension stop faces towards metal bumper
located in middle of groove [Figure 11].
4
Insert desired flexion stop into lower half of groove with notch
facing towards metal bumper [Figure 12].
5 Close stop cover and replace screw.
WArNING
this knee brace is a supportive brace only and is not intended or
guaranteed to prevent knee injury. Purchaser agrees to the following:
1
Össur accepts no responsibility for any injury which might occur
while using Össur knee bracing products.
2
With use of this type of device, it is possible to receive various
types of skin irritation, including rashes and pressure points. If you
experience any unusual reactions while using this product, consult
your health care provider immediately.
3 If you have any questions as to how this brace applies to your own
specific knee condition, consult your health care provider.
If you do not agree to the above conditions, contact your brace
provider before using this product.
7