6
Commands and Accessories
the parameters
N.A. (Normally Open) .
N.C. (Normally Closed).
CONTACT
9 (COR)
10
+
9
10
COR
12(+LAM)
11(COM)
13(+ES)
11(COM)
14(+24V)
11(COM) Power feed for external devices max 10 W (400 mA). See technical characteristics.
16(SC)
15(COM)
16(SC)
15(COM)
18(FT2)
15(COM) Input (NC) for connecting photocells FT2
19(FT1)
15(COM) Input (NC) for connecting photocells FT1
48
and
.
DESCRIPTION
Output (potential free contact) for connecting courtesy light.
eter
The function of the indicator lamp is determined by parameter
Set the parameter
to enable the test function.
to check that the contact changes state correctly.
Power feeds for all external devices (excluding the external radio receiver) may be con
nected to reduce battery consumption (if batteries are used). Set
WARNING! If contact 16-SC is used for the photocell test function or battery saving fun
The photocells FT2
–
. Photocell FT2 disabled when door is opening.
–
. Photocell FT2 disabled when door is closing.
–
. The door opens when an open command is received if photocell FT2 is
obstructed.
parameters
and
WARNING! Use R90/F4ES G90/F4ES or T90/F4S series photocells.
The photocells FT1
–
. Photocell triggers only during door closure. Photocell is ignored during door
opening.
–
. Movement is reversed if the photocell is triggered during door closure.
–
. The door opens when an open command is received if photocell FT1 is
obstructed.
parameters
and
WARNING! Use R90/F4ES G90/F4ES or T90/F4S series photocells.
duty cycle 50%).
(12 Vdc 15 W).
.
.
.
.
11(SC).
or
15(COM) - 18(FT2) or set the
15(COM) - 19(FT1) or set the
.