OHAUS i-DT61XWE Manual De Instrucciones página 5

6. Disassemble the cable gland by loosening the cap nut and removing
the rubber seal. Pass the cable through the cap nut, and then spread
the rubber seal and place it over the cable. After that, pass the cable
through the cable gland.
7. Connect the cable to the connectors on the analog board.
8. Pull in the bottom of the indicator. Re-install the 4 screws (Torque is
1.8N*m±0.5). Fasten the cap nut of the cable gland.
EN-3