OHAUS i-DT61XWE Manual De Instrucciones página 3

INTRODUCTION
This discrete I/O interface Kit is for use with the OHAUS i-DT61XWE indicator.
When installed, the system software allows the relay to be programmed in various
ways.
BASIC APPLICATIONS
Applications include driving external Over/Accept/Under displays, motor controls
for semi-automatic filling systems, sorting systems, interfacing to industrial PLC
systems, etc. The Relay outputs can also be used as slave relays to drive high
power relays in larger systems.
For the setup in each application, please refer to the indicator's instruction manual.
Set up the discrete I/O controls as described in the I/O menu section of that
manual.
CAUTION: Read all safety warnings before installing, connecting, or
serving the Discrete I/O PCB board. Failure to comply with these warnings
could result in personal injury and/or property damage. Retain all
instructions for future reference.
KIT CONTENTS
Screws (4)
I/O PCB
Connector, 3 Pin
Cable to mainboard
Cable Gland
Connector, 6 Pin
EN-1