OHAUS i-DT61XWE Manual De Instrucciones página 7

For the USB application:
9. Connect the cable to the connectors on the RS232/485/USB board.
On the RS232/485 board:
On the USB board:
10. Toggle the function switch to the function you need (check the following table
1 for details).
11. Pull in the bottom of the indicator. Re-install the 4 screws (Torque is
1.8N*m±0.5). Fasten the cap nut of the cable gland.
RS232 cable / RS485 cable
USB Device cable
EN-5