EN-6
SETUP
A two-position switch block is located on the main PCB board. Please check the
following table 1 for the function of the switch.
Table 1
Switch
SW-1
0
0
Position
1
1
Note: Only one function mode can be used at a time.
RS232/RS485/USB Device Function
A) The OHAUS Interface is preset to communicate using the following settings:
9600 baud, 8 bits, no parity, no handshake. Check the RS232/RS485/USB
device parameters required for the printer or computer that is to be connected.
Check the computer or printer documentation if assistance is required. If the
parameters do not match, you will need to change either the indicator's, the
computer's or the printer's settings.
B) Upon installation of the interface, the indicator will recognize the
RS232/RS485/USB device interface and add relevant items to the menu.
Configure the indicator to the desired RS232/485/USB device and printing
parameters; refer to the indicator's user manual for assistance.
Switch
USB
Device
COM 1
SW-2
Function
0
1
0
USB Device
1
RS485 Active Terminator
RS232
RS485