Torque Limiter - V2 HYPERFOR Manual De Instrucciones

RELEASE OF THE MOTOR
In the absence of power, the gate can be released
by operating on the motor:
1. Open the rear hatch
2. Screw anti-clockwise (left thread) the ring nut
K using the supplied 19" wrench until the
pinion is released
To restart the automation proceed as follows:
1. Screw clockwise (left thread) the ring nut K
up to the limit given by screw L
2. Close the rear hatch

TORQUE LIMITER

To adjust the motor torque, follow the instructions
below:
1. Open the rear door
2. Unscrew and remove screw L with the supplied
4" Allen wrench
3. Screw clockwise (left thread) the ring nut K
using the supplied 19" wrench until removal is
complete
4. In order to set the motor torque, operate the
self-locking nut M with a 27 wrench:
- screw by half turn nut M to increase the
torque; operate the motor to verify if the
torque is the desired one; if necessary, screw
again nut M until the desired value is
reached
- unscrew by half turn nut M to decrease the
torque; operate the motor to verify if the
torque is the desired one; if necessary,
unscrew again nut M until the desired value
is reached
5. After the adjustment is completed, screw
anti-clockwise (left thread) the ring nut K up to
thread end.
NOTE: if you overtighten the ring nut the
motor is released
6. Fully screw screw L
7. Close the rear door
12