RESQ SMARTLINE X Instrucciones De Uso página 10

9 . 1 . B O D Y H O L D I N G D E V I C E
The Smartline X device may be used in combination with a sit-harness to EN813, a full body harness to EN361 or a rescue har-
ness according to EN1497. It shall be attached to the harness as recommended by the manufacturer..
9 . 2 . A N C H O R A G E S
The anchor sling may be used on constructions without permanently installed anchors. The anchor sling should preferably be placed
around bearing parts of the construction, and must be able to support a minimum load of 12 kN. The karabiner may also connect
directly to a part of the structure as long as this part supports a load of 12 kN and does not cause unintended strain on the karabiner.
If special designed anchors are used, these shall conform to EN795.
9 . 3 . L O G A N D D O C U M E N T A T I O N
This manual should always accompany the equipment. In the form on the last page, all specific information about the equipment
must be filled in if not connected to the CRESTO INSPECTOR data base. The user must fill in the dates for when the equipment
has been taken into use, and all periodic checks or repairs the equipment has been through. The owner of the equipment is res-
ponsible for keeping this log updated, weather it refers to the hard copy or the INSPECTOR file.
9 . 4 . C O M P L I A N C E
As a manufacturer, CRESTO AB declares that their Smartline X device is in accordance to the PPE Regulation 2016/425 and that
it is tested and approved in accordance with the European standard EN 341 class D. Download your User instruction and
Declaration of conformity on http://www.cresto.com/documentation
EC Type-examination by:
FORCE Certification A/S
Park Allé 345
DK-2605 Brøndby
Phone: +45 43 25 01 77
Fax: +45 43 25 00 10
E-mail: info@forcecertification.com
Production Control by:
Notified Body: 0200
Force Certification A/S
RESQ Smartline X | EU 2019-04-21 | v.2 | Master EN | 9