N S P E C T I O N O F E Q U I P M E N T; S I N G T H E S M A R T L I N E X - RESQ SMARTLINE X Instrucciones De Uso

The Smartline X is a complete system, which consists of the following parts
(see fig. 1):
1. 1 Smartline X descender, including a handle to regulate the speed.
2. 1 aramid line (different lengths available).
3. 1 connected mini shock absorber (screamer).
4. 1 connecting shackle between shock absorber and line.
5. 1 karabiner to connect the descender device to a body holding device.
6. 1 anchor sling EN795 cl.B, for anchoring to an anchor point/construction.
Aramid, (Sling in Polyamide is optional).
7. 1 karabiner to connect the line to the sling.
8. 1 marking label.
9. 1 kit bag to protect the equipment.
NOTE: The handle is secured to the body of the Smartline X device by a
safety seal. When opening the handle, the seal pops away!
The Smartline X has been produced as a compact light package. This has
been possible due to the special line made from Aramid. In addition to high
resistance to mechanical wear and strength compared to its small diameter,
the descent line has an extremely high melting point (˃450 °C).
4 I N S P E C T I O N O F E Q U I P M E N T
Before using the Smartline X kit, inspect:
• That the seal between handle and body is intact.
• That there is no visible damage on the equipment.
• That there is no visible damage on other equipment to be used with the Smartline X.
• That the descent line is long enough for the actual descent.
• That there´s no knots or entanglement along the line.
5 U S I N G T H E S M A R T L I N E X
5 . 1 . G E N E R A L A D V I C E
Rescue equipment should only be used by persons who are properly trained and are familiar with how to use the equipment in a
safe manner, or during training and under direct supervision of qualified instructors.
The Smartline X kit is meant to be carried on the harness to be available if an emergency situation arises, and it can be located at
different places on the harness. We recommend placing it at the lower back/right or left to avoid conflict with other equipment that
might be in use.
If you have questions about the use of this equipment, please contact CRESTO AB.
5 . 2 . R E S T R I C T I O N S O N U S E
• The Smartline X must ONLY BE USED ONCE! After use the Smartline X must be inspected by an approved body, in
order to determine if it is safe to re-fit!
• The Smartline X is only approved for one person and a total weight between 60kg to 140 kg.
• The Smartline X can be used under dry, wet and cold conditions in temp. ranging from plus 50 to minus 25°C. If the general
working conditions is artic (average ˂ - 4°C) a sealed pack is recommended to ensure optimal descend conditions on light loads
(60kg).
6
RESQ Smartline X | EU 2019-04-21 | v.2 | Master EN |
7
3
4
8
9
5
2
1
Fig. 1
3