Chicago Faucets 785 Nstrucciones De Instalacion página 17

Swivel Fittings
INSTALLATION INSTRUCTIONS
These installation instructions apply to swivel fittings on 8" or 12" centers.
1. Disassemble and remove all parts (items 4, 10-15) from spout base. (Note sequence of
assembly).
2. Apply putty or assemble rubber washer to underside of spout base to assure a good seal and
level fit.
3. Place spout body shank through hole in sink and assemble mounting hardware to shank.
Tighten securely.
4. Assemble coupling nut, brass washer and rubber washer to copper tubing on both swivels and
HAND TIGHTEN coupling nuts to side bodies.
5. Assemble below deck mounting hardware to side bodies.
6. Place (1) 1" diameter flat gasket (item 12) in recess of upper swivel.
7. Align upper swivel assembly with hole in sink and spout shank, then assemble above deck
mounting hardware to side body to hold in place.*
8. Place (1) 1" diameter flat gasket (item 12) in recess of lower swivel.
9. Align lower swivel assembly with hole in sink and spout shank, then assemble above deck
mounting hardware to side body to hold in place.*
10. Hand tighten above deck locknuts until side bodies protrude evenly 9/16" above deck or use
VALVE BODY HEIGHT GAGE to measure to correct height.
11. Assemble gasket, retainer and locknut (in that order) to extended nipple below swivels.
12. Secure fitting to deck by tightening locknuts from below deck.
13. Assemble supplies.
14. For installation and adjustment of cartridges refer to pages 20-32.
15. If escutcheons are included, assemble to fitting and tighten down using escutcheon nuts. If
desired, apply a bead of plumbers putty around locknut before assembling escutcheons.
16. For installation of spout (if required) refer to pages 33-34.
17. For installation of waste fitting (if required) refer to pages 35-37.
18. After completion of installation, remove aerator and flush lines and faucet for approximately
one minute.
NOTE: For faucets that are furnished with 12" center to center swivels, but sink holes are on 8"
centers, shorten swivel tubes by cutting off 2" from each tube with tube center.
16