JVC DT-V9L5 Manual De Instrucciones página 11

7 HDMI terminal
Input terminal compatible with HDCP for the HDMI signal. (TYPE-A)
8 REMOTE terminal
Terminal for controlling the monitor by an external control. (☞ "External Control" on page 23)
9 AUDIO (MONITOR OUT) terminals (pin jack)
Output terminals for the analog audio signal.
●
The terminals emit the audio signals through the AUDIO (IN) terminal or EMBEDDED AUDIO signals through the E. AUDIO HD/SD SDI (IN 1
or IN 2) input terminal.
●
The signal is output from this terminal only when the monitor is on or in "Power Save" (power save) mode (☞ "No Sync Action" on page 18).
●
The EMBEDDED AUDIO signal...
– is decoded into an analog signal, then emitted.
– is emitted only when "SDI 1" or "SDI 2" is selected, and when EMBEDDED AUDIO signals come in to the E. AUDIO HD/SD SDI (IN 1 or IN 2)
terminal.
●
Audio signals are only output from the HDMI terminal when the signals are not protected by HDCP.
– Even when the signals are protected by HDCP, sound is emitted from the speakers.
p E. AUDIO HD/SD SDI (IN 1, IN 2) terminals (BNC)
Input terminals for the HD/SD SDI signals.
●
The terminals accept also EMBEDDED AUDIO signals including up to 16 audio channels with a sampling frequency of 48 kHz.
q E. AUDIO HD/SD SDI (SWITCHED OUT) terminal (BNC)
Output terminal for the HD/SD SDI signals.
●
The SDI signals of the current input (SDI 1 or SDI 2) are re-clocked, then emitted.
●
When an input other than SDI 1 and SDI 2 is selected, the SDI signal of the input selected last time is emitted from this terminal.
●
The signals are emitted from this terminal only when the monitor is on or in "Power Save" (power save) mode (☞ "No Sync Action" on
page 18).
w Screw holes for external battery attachment
Attach external battery for DC power supply by using 2 screw holes. Choose the appropriate screw holes from 1, 2 or 3 according to the type
of external battery. (Depending on the battery type.)
Use the Anton Bauer Dionic 90 (mount: QR DXC-M3A) external battery.
CAUTION
●
Do not use the external battery for DC 24 V power supply.
●
Use only the battery specified above. If a heavy battery is used, it may fall off depending on the way the monitor is used.
Note for connections
•
Before making any connections, turn off all the equipment.
•
Use a cord whose plugs correctly match the terminals on this monitor and the equipment.
•
Plugs should be firmly inserted; poor connections could cause noise.
•
When unplugging a cord, be sure to grasp its plug and pull it out.
•
DO NOT connect the power cord until all connections are complete.
•
Refer also to the user manual of each piece of equipment.
Attaching the power cord holder
The provided power cord holder prevents accidental disconnection of the AC power cord from the AC IN terminal.
●
The power cord holder consists of two parts, a case and a cover.
1
AC IN terminal
CAUTION
●
Use only the provided screws.
●
Make sure the plug will not be pulled out after the cover is attached to the case.
2
Case
Cover
3
To detach the cover
9
EN EN