Metabo BZ 9.6 SP Instrucciones De Manejo página 10

ENGLISH
ENG
comes into contact with your skin, rinse imme-
diately with plenty of water. If battery fluid leaks
out and comes into contact with your eyes,
wash them with clean water and seek medical
attention immediately!
Only use suitable Metabo chucks (order no.
3.01.00.301.0) when using the machine.
5 Overview
See page 3 (please unfold).
1 Rapid-action keyless chuck
2 Selector barrel (torque, drilling)
3 Slide-switch (1st/2nd gear)
4 Battery-pack release button
5 Battery pack
6 Depot for screwdriver bits
7 Trigger switch
8 Changeover switch (direction of rotation
setting, transporting safety device)
6 Operation
Charge the battery pack before use.
The battery pack reaches its full capacity only
after being charged and discharged 5 times
(charge cycles).
The maximum number of charge cycles can
only reached if an exhaustive discharge of the
battery pack is avoided. If performance dimin-
ishes, recharge the battery pack.
Store NiMH battery packs when charged and
recharge after 6 months at the latest.
6.1 Removing and replacing the battery-
pack
Removing
Press in the release button (4) and remove the
battery pack (5).
Replacing
Push the battery pack (5) fully into its housing
until it locks into position.
6.2 Setting the direction of rotation,
engaging the transporting safety
device (switch-on lock)
Only activate the changeover switch
(8) when the motor is at a standstill!
Activate the changeover switch (direction of
rotation setting, transporting safety device) (8).
10
See page 3 (please unfold):
R = right-hand rotation selected
L = left-hand (reverse) rotation selected
0 = central setting: transporting position
(switch-on lock engaged)
6.3 Selecting gear
Do not operate the slide-switch (3)
unless the motor is at a standstill.
Position the slide-switch (3) as required:
= 1st gear (low speed, exceptionally high
torque)
= 2nd gear (high speed)
6.4 Setting torque control,
drilling
Turn selector barrel (torque, drilling) (2).
1...20 = Torque setting
(with torque control)
= Drill setting
(max. torque)
6.5 Switching the power tool on and off,
setting speed
Position the trigger-switch (7) as required.
The speed can be set to any value within its
range.
Note:The noise that the machine makes when
it is switched off is due to the model (quick
stop) and has no influence on the function or
the service life of the machine.
6.6 Rapid-action keyless chuck
9
GRIP, ZU
Opening
Twist the sleeve (9) towards "AUF, RELEASE".
AUF, RELEASE