Before You Begin - Kohler K-3092 Guia De Instalacion

Ocultar thumbs Ver también para K-3092:
Tabla de contenido

Publicidad

Recommended Tools and Materials
Measuring Tape
Square
Safety Glasses

Before You Begin

CAUTION: Risk of personal injury and product damage. Mirror cabinets are very heavy. Get assistance
when lifting the cabinet.
DANGER: Risk of electric shock. Connect only to a circuit protected by a Ground Fault Circuit Interrupter
(GFCI).
- If installing multiple Purist components (cabinet, countertop, lavatory, etc.) read all product installation
instructions before beginning. Some components should be installed before others. Refer to lavatory or wall
mount cabinet Homeowners Guide for sample configurations and all necessary components.
- When installing this product in an area with unfinished walls or in conjunction with other components in the
Purist suite, it is recommended bracing be installed. When installing this product in an area with a finished wall,
use the wall anchors supplied for installation.
- Remove the cabinet from its carton and inspect for damage.
- Confirm the contents of the box; shelving, mounting Z" bar and hardware. Hardware bag should contain:
(3) top clips
(2) connecting blocks
(6) polyset anchors
(6) #10 x 2" screws
(10) #10 x 1/2" screws
(15) screw dome caps
(9) shelf clips
(2) spacer blocks
(2) touch up markers
(1) screw/dome kit
- Models K 3092 and K 3093 have end caps included; a separate end cap kit for these models is not necessary.
- All plumbing rough ins must be established and installed in the correct location before installation of the mirror
cabinet can begin. A 90 degree shut off valve with 3/8" compression outlet must be used.
- Make sure electrical power can be provided before beginning the installation. Power to the cabinets should be not
be controlled by the light switch.
- The installation must have a Class A Ground Fault Circuit Interrupter (GFCI). The GFCI protects against
line to ground shock hazard. Use a 120 V, 20 A, service.
- Do not complete the finished wall until all needed plumbing and electrical rough ins have been completed.
- If installing bracing, do not complete the finished wall until braces for each component in your installation have
been installed.
NOTE: Mirrored door function is for servicing electrical components and faucet only. Use sliding drawer for
storage access.
- Observe all local plumbing and building codes.
B
1011414-2-
#2 Phillips Screwdrivers
Drill
Level
Pencil
Adjustable
Wrench
2
Masking
Tape
2x4 Lumber
Kohler Co.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

K-3093

Tabla de contenido