Sauder Edge Water 419396 Guía De Ensamblaje página 13

Step 9
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (E) and lay it over your unit with the fl ap folded
under the top as shown.
Make equal margins along the side and bottom edges
å
of the BACK (E). Push on opposite corners of your unit if
needed to make it "square".
Fasten the BACK (E) to your unit using the NAILS (1N).
å
Fasten the upper fl ap of the BACK to the TOP (C). Use
å
fi ve BLACK 9/16" LARGE HEAD SCREWS (1S).
BLACK 9/16" LARGE HEAD SCREW
(5 used for the BACK FLAP)
www.sauder.com/services
1S
E
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Fold the BACK underneath the TOP.
419396
1N
NAIL
(17 used in this step)
C
Page 13