Schlage LE Instrucciones De Instalación página 7

5
Partly install the key cylinder.
Turn key cylinder into the chassis. Tighten just enough to
secure outside trim. Insert key, then pull out one notch to aid
with turning.
6
Install inside spindle, spring cage, and mounting plate.
Arrows on the spring cage point in direction of lever down
rotation.
7
Connect the cables to the inside assembly
There are two cables that need to be connected.
NOTICE
Do not tighten more
than six full turns!
Tighten fully at step 9!
INTERIOR
Cable slack
should
be folded
downward.
For deadbolt only:
Align driver bar into the
chassis. Thumbturn must
be vertical when deadbolt
is retracted.
8
Install the inside assembly.
Actual Size (2 mounting screws)
Actual Size (bottom screw)
Phillips or T-25 security screw
Black finish
9
Fully tighten the key cylinder and chassis screws.
The cylinder face needs to be flush to the outside
escutcheon. Tighten the cylinder mounting screw.
Cylinder
mounting
screw
7