Unpacking; Installation And Setup; General Setup - Coltene BioSonic UC150 Guia Del Usuario

4. Unpacking

Figure 1 UC150 Parts and descriptions
• Remove your BioSonic unit from the shipping container and inspect the unit for any possible
damage which may have occurred during shipping.
• Check the serial number of the unit (found on either the underside or rear of the unit) with the
number on the shipping carton. If they are not identical, contact your dealer.
• Register your product warranty at: http://warranty.coltene.com

5. Installation and Setup

General Setup

• Select your desired location for the cleaner. It should be on a solid level top and in close
proximity to a sink or to waste lines to facilitate draining. The hose supplied with the unit will
allow you to place the unit on the left side of the sink or connect directly to the waste line.
• Connect one end of the hose to the drain valve
desired, have your plumber connect the hose directly to the waste line with the appropriate
fittings.
• CONNECT THE DISPLAY. Attach the connector on the bottom of the display module to the
connector on the top right-hand corner of the unit. Press the display module down carefully
until it snaps into the right position.
6
(Figure 4)
and place the other end in the sink. If