Installing The Recoil-Starter Rope In The Rope Guide; Filling The Engine With Oil - Toro Recycler 20370 Manual Del Operador

2
Installing the Recoil-starter
Rope in the Rope Guide
No Parts Required
Procedure
Important: To start the engine safely and easily
whenever you use the machine, install the recoil-starter
rope in the rope guide.
Hold the blade-control bar to the upper handle and pull the
recoil-starter rope through the rope guide on the handle
(Figure 4).
1. Recoil-starter rope
Figure 4
2. Rope guide
3

Filling the Engine with Oil

No Parts Required
Procedure
Your machine does not come with oil in the engine.
1. Remove the dipstick (Figure 5).
2. Slowly pour oil into the oil-fill tube until the oil level
reaches the Full line on the dipstick (Figure 5). Do not
overfill. (Max. fill: 22 oz. (0.65 l), type: 10W-30 or
SAE 30 detergent oil with an API service classification
of SJ or higher.)
Note: Each time you check the oil level, remove the
dipstick and wipe it clean, insert it into the oil filler
neck (but do not screw it in), then remove it again and
check the level (Figure 5).
Note: If you overfill the engine, pour some oil out of
it; refer to Changing the Engine Oil (page 12).
3. Install the dipstick securely.
Important: Change the engine oil after the first 5
operating hours ; change it yearly thereafter. Refer
to Changing the Engine Oil (page 12).
5
G020008
Figure 5