Remote Control; Remote Sensor - Pioneer X-HM30V-S Manual De Instrucciones

System Connection (continued)
n Connect your TV (For TV audio)
This will allow you to play the sound from the TV's built-in
tuner.
Connect the audio output on your TV to the LINE IN on
l
this receiver.
Use an audio cable.
TV
Main unit
AC IN
S-VIDEO
To select Line In function:
On main unit: Press INPUT button repeatedly until
l
Line In is displayed.
On remote control: Press LINE button.
l
All manuals and user guides at all-guides.com
To audio
output sockets
Audio cable
(commercially
available)
To LINE
input
sockets
LINE AUX
LOOP
COMPONENT VIDEO
HDMI COAXIAL
En-12

Remote control

n Battery installation
1 Open the battery cover.
2 Insert the supplied batteries according to the direction
indicated in the battery compartment.
When inserting or removing the batteries, push them
towards the (–) battery terminals.
3 Close the cover.
WARNNIG:
Do not use or store batteries in direct sunlight or other
l
excessively hot place, such as inside a car or near a
heater. This can cause batteries to leak, overheat,
explode or catch fire. It can also reduce the life or
performance of batteries.
Caution:
Replace all old batteries with new ones at the same
l
time.
Do not mix old and new batteries.
l
Remove the batteries if the unit will not be used for a
l
long period of time. This will prevent potential damage
due to battery leakage.
Do not use rechargeable batteries (nickel-cadmium
l
battery, etc.).
Installing the batteries incorrectly may cause the unit to
l
malfunction.
Notes concerning use:
Replace the batteries if the operating distance is
l
reduced or if the operation becomes erratic. Purchase
2 "AAA" size batteries.
Periodically clean the transmitter on the remote control
l
and the sensor on the unit with a soft cloth.
Exposing the sensor on the unit to strong light may
l
interfere with operation. Change the lighting or the
direction of the unit if this occurs.
Keep the remote control away from moisture, heat,
l
shock, and vibrations.
When disposing of used batteries, please comply with
l
governmental regulations or environmental public
instruction's rules that apply in your country or area.
n Test of the remote control
Check the remote control after checking all the
connections.
Point the remote control directly at the remote sensor on
the unit. The remote control can be used within the range
shown below:

Remote sensor

7 m
STANDBY/ON
MEMORY/FOLDER