Megger MET1000 Guia Del Usuario página 8

Voltage/Continuity/Single Pole Mode
Single Pole Phase Check
Neutral
G
Warning
„ The MET1000 Single Pole Check feature consists of using only one test lead
connected to the MET1000, remove second test lead if fitted.
„ To carry out Single Pole Check test, while firmly holding the MET1000 connect the
test lead into a live circuit, this will cause the MET1000 to repeatedly beep and the
hazard symbol to illuminate without any voltage being displayed on the screen.
„ If a voltage appears on the screen then use 2 Pole method to prove the circuit live.
8
Live
Grip firmly
Detach lead
www.megger.com