Operating Instructions - Flex SFE 8-2 115 Instrucciones De Funcionamiento Originales

SFE 8-2 115

Operating instructions

WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Before switching on the power tool
 Unpack the electric power tool and check
that no parts are missing or damaged.
 Attach sandpaper.
 Attach the handle.
Attaching or changing sandpaper
 Pull out the mains plug.
 If required, remove attached sandpaper
from the sanding disc (1.).
 Attach new sandpaper (2.).
Attach the handle
 Attach the auxiliary handle either to the left
or right side of the housing.
 To do this, put the handle on the thread (1.)
and turn clockwise (2.).
Changing the toothed belt
 If required, remove sandpaper from
the sanding disc.
 Loosen the 4 screws on the underside
of the sanding disc (1.).
 Remove sanding disc (2.).
 Remove felt from the rear cover (3.).
 Loosen screws on the rear cover (4.).
 Push rear cover to the side or remove (5.).
 Loosen front hexagon socket screw (6.).
 Remove toothed belt. To do this, strip
the toothed belt off the rear small cog (7.)
and pull forwards (8.).
17