Maintenance And Care; Carbon Brushes - Flex SFE 8-2 115 Instrucciones De Funcionamiento Originales

SFE 8-2 115
Operating instructions
NOTE
When the electric power tool is switched off,
it continues running briefly.
– Do not place the sanding pad on the work-
piece until the power tool has reached full
speed.
– To obtain a good grinding result, move
the sanding pad evenly over the surface
which is to be ground down.
Do not apply excessive pressure.
– When the power tool is switched off,
the sanding pad continues running briefly.

Maintenance and care

WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Cleaning
WARNING!
If metals are ground or cut over a prolonged
period, conductive dust may become depo-
sited inside the housing. Impairment of the
protective insulation! Operate the power tool
via a residual-current-operated circuit-
breaker (tripping current 30 mA).
 Regularly clean the power tool and
ventilation slots. Frequency of cleaning is
dependent on the material and duration of
use.
 Regularly blow out the housing interior and
motor with dry compressed air.

Carbon brushes

The electric power tool features cut-off
carbon brushes. When the cut-off carbon
brushes reach their wear limit, the electric
power tool switches off automatically.
NOTE
Use only original parts supplied by the manu-
facturer for replacement purposes.
If non-original parts are used, the guarantee
obligations of the manufacturer will be
deemed null and void.
When the power tool is being used, the
carbon brushes can be seen sparking
through the rear air inlet apertures.
If the carbon brushes are sparking
excessively, switch off the electric power tool
immediately. Take your electric power tool to
a customer service centre authorised by the
manufacturer.
Gears
NOTE
Do not loosen the screws on the gear head
during the warranty period.
Non-compliance will deem the guarantee
obligations of the manufacturer null and void.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
Spare parts and accessories
Sanding belts and sanding arms for different
application areas and other accessories can
be found in the manufacturer's catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com
19