Before Initial Use; Set-Up And Connection - Beem FRESH-AROMA-SELECT Manual De Instrucciones

23

Before Initial Use

1. Remove any fi lms and stickers which are used for advertising or protection during transporta-
tion. Never remove the rating plate and any possible warnings.
2. Wipe the device with a clean, damp cloth. Clean the permanent fi lter (2) and the coffee jugs
with mild detergent and warm water.
3. Set up the device (see the "Set-Up and Connection" chapter).
4. Before you enjoy your fi rst coffee, we recommend that you carry out a trial run to remove
any possible production residues in the water system. To do this, follow the instructions in the
"Preparation" chapter.
When the device is fi rst used, production-related additives (e.g. grease) may cause a small
amount of smoke and / or an odour to be produced. This is normal and not a device defect.
5. Repeat this process twice. Do not drink this coffee!
6. Clean the device and accessories (see the "Cleaning and Care" chapter).

Set-Up and Connection

PLEASE NOTE
• Always set up the device with a clear space at the sides (at least 20 cm) and clear space
above it (at least 30 cm) on a fl at, solid and heat-resistant surface that is resistant to
splashing.
• Do not place the device below kitchen wall units or similar cupboards. The rising steam
could cause damage to them!
• The surfaces of furniture may possibly contain elements which can attack and soften
the adjustable feet of the device. If necessary, place a suitable pad below the adjustable
feet.
•
Place the device in a suitable location, following the safety notices and the notices provided at
the beginning of this chapter.
• Fully unwind the connection and insert the mains plug into a properly installed socket that is
easily accessible.
05958_DE-EN-FR-ES-IT_A5_V1.1.indb 23 05958_DE-EN-FR-ES-IT_A5_V1.1.indb 23
EN
18.01.2019 07:56:39 18.01.2019 07:56:39