Uline H-1030 Manual De Instrucciones página 10

PISTON REPLACEMENT
1. Remove screws and nut with 8mm Spanner wrench
and 4 mm Allen wrench. (See Figure 24)
2. Remove magazine assembly. (See Figure 25)
3. Loosen set screw with a 3mm Allen wrench to unlock
the adjusting rod.
4. Slide linkage mechanism and adjusting rod
simultaneously from collar.
5. Loosen collar with a 3mm straight rod to remove the
spring. (See Figure 26)
Figure 24
Cap
Figure 27
PAGE 10 OF 30
OPERATING INSTRUCTIONS CONTINUED
Figure 25
Figure 28
1-800-295-5510
6. Loosen screw with a 3mm Allen wrench and remove
the block through the window.
7. Loosen screws with a 3mm Allen wrench and remove
the cap. (See Figure 27)
8. Remove the piston assembly with a 10mm Spanner
wrench. (See FIgure 28)
9. Remove piston and replace.
Magazine Assembly
Piston Assembly
uline.com
Figure 26
Spring
0421 IH-1030