Ecoflam SmartFlam MAX P 35 AB TC TW 230-50 Manual Del Usuario página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 72
EN
Contents
- Index - General warnings - Conformity declaration
Overview
Technical data
Working fields
Dimensions
Contents
Index
General warnings
Burner description
Function
General safety functions
TCH 2xx control box
Terminal allocation chart 230 Volt connection
Terminal allocation chart low voltage connections
Oil burner pump
Installation
Burner assembly
Electrical connection - Checks before commissioning
Oil feeding and suction line - Setting data table
Start up
Pre-setting without flame
Adjusting burner output - Oil pressure regulation
Setting the flame
Operating mode
Saving the adjustment values in the display
Service
Maintenance
Troubleshooting
Fault diagnosis menu
Operating statistics menu
Overview
Electrical diagrams
Spare parts list
Contents
Conformity declaration
Important notes
MAX P 35-45 AB burners are designed for
the combustion of domestic fuel oil EL in
accordance with EN267 standards.
Assembly, commissioning and
maintenance must be carried out only by
authorised specialists and all applicable
guidelines and regulations must be
observed.
Burner description
MAX P 35-45 AB are two-stage, fully-
automatic monoblock-type burner. It is
suitable for use, within its range of
performance, with boilers complying with
EN 303 or hot-air generators in line with
DIN 4794, DIN 30697 or EN 621.
Use for any other application requires the
approval of Ecoflam.
The following standards should be
observed in order to ensure safe,
environmentally sound and energy-efficient
operation:
Ecoflam burners have been designed and built in compliance with all current regulations
and directives.
All burners comply to the safety and energy saving operation regulations within the standard
of their respective performance range. The quality is guaranteed by a quality and management
system certified in accordance with ISO 9001:2008.
6
www.ecoflam-burners.com
EN 226
Connection of vaporising oil and forced
draught gas burners to the heat generator.
EN 60335-2
Safety of electrical equipment for domestic
use.
Installation location
The burner must not be operated in rooms
containing aggressive vapours (e.g. spray,
perchloroethylene, hydrocarbon
tetrachloride, solvent, etc.) or tending to
heavy dust formation or high air humidity.
Adequate ventilation must be provided at
the place of installation of the furnace
system to ensure a reliable supply with
combustion air.
Variations may arise as a result of local
regulations.
We can accept no warranty liability
whatsoever for loss, damage or injury
caused by any of the following:
- Inappropriate use.
- Incorrect assembly or repair by the
customer or any third party, including the
fitting of non-original parts.
Provision of the system and the
operating instructions
The firing system manufacturer must
supply the operator of the system with
operating and maintenance instructions on
or before final delivery. These instructions
should be displayed in a prominent
location at the point of installation of the
heat generator, and should include the
address and telephone number of the
nearest customer service centre.
Notes for the operator
The system should be inspected by a
specialist at least once a year. It is
advisable to take out a maintenance
contract to guarantee regular servicing.
420010492200
3
4
5
6
6
7
8
9-10-11
12
13
14
15
16
17
18
19
20
21
22
23-24
25
26
27
116-119
120-121
122

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Smartflam max p 45 ab tc tw 230-400-50Smartflam max p 35 ab tl tw 230-50Smartflam max p 45 ab tl tw 230-400-50314042031404213140933 ... Mostrar todo

Tabla de contenido