Install The Nozzle; Start The Machine; Stop The Machine; Maintenance - GreenWorks GPW2000-1RBSC Manual Del Operador

EN
SPRAY TIP APPLICATION
Black - Soap spray tip
•
SOAP
4.3.2

INSTALL THE NOZZLE

1. Pull back the quick-connect collar (21) on the spray wand
(4).
2. Install the nozzle (11) onto the spray wand (4).
3. Release the quick-connect collar (21) to attach the nozzle
(11).
4.4

START THE MACHINE

Do not operate without the water supply connected.
Before you start the machine:
1. Turn the water supply on.
2. Pull the gun trigger to release air pressure.
3. If a stable stream of water comes out from the gun,
release the gun trigger.
1. Connect the machine to the power supply.
2. Set the power switch to the "ON" ( | ) position.
3. Turn the water supply on.
4. Pull the gun trigger.
4.5

STOP THE MACHINE

1. Release the spray gun trigger.
2. Press down on the ON/OFF switch, once again, to set the
power switch to the "OFF" (O) position.
The black soap spray tip, is used for
soap application. Soap is applied un-
der low pressure high volume for op-
timum performance. Soap cannot be
applied under high pressure with this
machine.
CAUTION
CAUTION
English
If you do not use the machine：
• Stop the machine.
• Turn the water supply off.
• Disconnect the power cord from the outlet.
• Pull the spray gun trigger to release the remaining
pressure from the machine.
• Engage the trigger safety lock-out on the spray gun.
5

MAINTENANCE

Before maintenance, make sure that you
• Stop the machine.
• Wait until all the moving parts stop.
• Disconnect the plug from the power source.
Do not use strong solvents or detergents on the plastic
housing or components.
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Replace the power cord by an approved service center.
5.1

NOZZLE MAINTENANCE

23
11
10
WARNING
WARNING
WARNING
WARNING
WARNING