Grohe VERIS F-DIGITAL 36 345 Manual Del Usuario página 7

Fault Cause
Water does not flow • Water supply interrupted
• Plug-in connector without contact or no voltage
supply
Flow rate too low • Faucet flow regulator dirty or defective
• Functional unit not adapted to local conditions
Water too cold/hot • Functional unit not adapted to local conditions
No function • No voltage supply to functional unit
• Digital controller not ready or registered
• Digital controller out of range
Segment flashes 1x white
• Radio interference
• Obstacle in transmission path
• 1x: Batteries digital controller almost empty
• 2x and water pulses: Battery functional unit
Segment flashes green
almost empty
• 2x without water pulses: Battery functional
unit not connected or empty
• 3x: Temperature too high
• Software malfunction
Segment flashes 1x yellow
• Hard- or software malfunction
Segment flashes 1x red
Please pass these instructions on to the end user of the fitting.
The right to make technical modifications is reserved.
English
Remedy
- Open shut-off valves, isolating valves
- Attach plug-in connectors and connect voltage supply
- Replace flow regulator, see section Maintenance
- Adapt functional unit to local conditions, see Function F2 - Setting
mode
- Adapt functional unit to local conditions, see Function F2 - Setting
mode
- Connect voltage supply via voltage supply unit
- Register digital controller, see Function F3 - Register/de-register
- Reduce distance or use special accessory transceiver
(order no 36 356)
- Deactivate potential source of interference and check function again
=> If positive reconfigure the interference source (eg wireless router)
- Rectify the fault see section Operating conditions
- Check installation or replace unit battery, see section Maintenance
- Check installation or replace unit battery, see section Maintenance
- Connect plug in-connector battery or replace battery, see section
Maintenance
- Wait until feeler gauge is cooling down
- Calibrate functional unit, see section F2 - Setting mode
- Switch off the voltage supply and consult a specialist installer
or the GROHE Service Hotline
- Switch off the voltage supply and consult a specialist installer
or return the product to GROHE
4