Nogueira NSG-9200 Manual De Instrucciones página 24

Installing the bag (continuation)
11- Pull the tray and the hanger at the same time,
placing the bag on the machine.
12- Lift the tray and hook the chains on the
existing stretcher hooks on both sides of the
machine.
There must be, between the tray and the
machine, sufficient gap to unfold the bag with
ease.
If this space is insufficient, while filling small
breaks may apper at the bottom of the bag. If
necessary, increase the clearance using existing
stiffeners on both sides of the machine (fig.51).
24
fig.50
fig.51
Instructions manual
13- After the bag is placed on the machine, pull
the bag on both sides to smooth out some folded
parts.
Stretch the bag to about from 2 to 3 meters and
then close its end.
It is important that the bag is well sealed.
14- Place the elastic strap (supplied with the
machine) wrapping it around the folded parts of
the bag. Tie the ends of it to the chains on the
tray.
The purpose of the strap is to hold the folded
parts of the bag, releasing them one by one as
the bag fills.
It is recommended to tie the strap on the
machine, in order to avoid from being pulled by
the bag. Cut 3 pieces of the thin rope and tie it to
one end of the loop on the machine, the other to
the strap, as shown in figure 53.
fig.52
fig.53