Environmental Protection; Troubleshooting - Worx WT463 Manual De Instrucciones

be observed.
ASSEMBLY AND OPERATION
Action
Blade Installation
Blade Removing
Variable Speed Control
Pendulum Function
ON/OFF Switch
Lock-On Button
Straight Cut and Curve Cut
Bevel Cut
Plunge Cut
Parallel Guide
Blade Storage
Vacuum Adaptor
MAINTENANCE
Remove the plug from the socket before

TROUBLESHOOTING

Symptom
Tool will not start when
power on
Poor cut quality
Work efficiency is low.
Blade is not clamped tightly
by the Blade Holder.
Jigsaw
Figure
See Fig. A1
See Fig. A2
See Fig. B
See Fig. C
See Fig. D
See Fig. D
See Fig.
E1,E2
See Fig. F ,G
See Fig. H
See Fig. I1,I2
See Fig. J
See Fig. K
Possible Causes
• Power cord is not plugged.
• Blade is worn out.
• Blade is assembled incorrectly
• Pushing rate is too fast.
• Blade is worn out
• Incorrect speed setting
• Incorrect Pendulum function
setting
• Blade is not inserted into
place fully.
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional
lubrication or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid
a hazard.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or retailer for
recycling advice.
Possible Solution
• Check to make sure power cord is
connected well into a working outlet.
• Make sure the blade is sharp and
not broken.
• Make sure the blade is installed properly.
Push the machine slowly.
• Change to a new blade.
• Adjust the variable speed control
according to the material
• Adjust the pendulum function
control according to the material
Dismantle the blade and reinstall it
correctly.
11
EN