Environmental Protection; Troubleshooting - Worx WX472 Manual Original

ENVIRONMENTAL
PROTECTION
This product has been marked with a
symbol relating to removing electric
and electronic waste. This means that
this product shall not be discarded with
household waste but that it shall be returned
to a collection system which conforms to the
European Directive 2012/19/EU. It will then
be recycled or dismantled in order to reduce
the impact on the environment. Electric and
electronic equipment can be hazardous for the
environment and for human health since they
contain hazardous substances.

TROUBLESHOOTING

Symptom
Tool will not start when
power on
Poor cut quality
Work efficiency is low.
Blade is not clamped
tightly by the Blade Holder.
Jigsaw
Possible Causes
• Power cord is not plugged.
• Blade is worn out.
• Blade is assembled incorrectly
• Pushing rate is too fast.
• Blade is worn out
• Incorrect speed setting
• Incorrect Pendulum function
setting
• Blade is not inserted into
place fully.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional
lubrication or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
Possible Solution
• Check to make sure power cord is
connected well into a working outlet.
• Make sure the blade is sharp and
not broken.
• Make sure the blade is installed properly.
Push the machine slowly.
• Change to a new blade.
• Adjust the variable speed control
according to the material
• Adjust the pendulum function
control according to the material
Dismantle the blade and reinstall it
correctly.
9
EN