Cyclone Assembly - Nogueira DPM-1 Manual De Instrucciones

Cyclone assembly

The cyclone is optional equipment, supplied when ordered. When it is purchased disassembled and
packaged. Follow these instructions for assembly:
Screw the end of the threaded rod to the cyclone
foot. Pass the other end through the existing
hole in the opening and put on the nut. See the
position of the nut and the locknut in the above
figure.
16
Insert the curved tube in the opening of the cyclone.
Insert the three feet in the existing slots on the body
of the cyclone.
Instructions Manual
Do not forget to insert the rubber ring before
installing the curved tube in the machine (A).