Lubrication - Nogueira DPM-1 Manual De Instrucciones

CHANGING THE HAMMERS
There are 4 toothed surfaces on the hammers (A) which can be repositioned as each one becomes
worn.
Proceed as follows to change the hammer surface or to replace the entire hammer:
1- Cut the locks (B) on the hammer pins.
2- Remove the hammer pins (C), make sure the position of the rings is correct in the spacer rings, and
be careful not to mix the sets of hammers, as this will interfere with the balancing of the machine,
causing vibrations.

Lubrication

1- The only places where lubrication is necessary
are the bearing housings (D).
2- Lubrication must be weekly.
Lubricate the bearing housings with a grease gun
(D), using special grease for bearings, lithium
soap base, NLGI 2 EP classification. An example
of this type of grease is: LUBRAX LITH-2.
Before lubricating, clean the grease fittings well, in
order to avoid contamination from the grease.
Replace damaged grease fittings.
The most efficient time to lubricate is at the end of
the working period, as the grease will flow better
while the machine is still hot.
22
Instructions Manual