Nogueira DPM-1 Manual De Instrucciones página 7

Safety
- Moveable parts and components, due to
inertia, they continue moving after the machine
stops operating.
Before touching any part, disconnect the
actuation source, look, and listen to see of there
is any evidence of movement. Only touch a part
if you are sure if is motionless. Always pay close
attention!
- Before starting the electrical installation of the
motor, make sure the local electricity is turned
off.
- The installation of electric motors must be
performed by a qualified electrician. The
dimensioning of the cables and the utilization of
starting devices must comply with currently
applicable safety standards.
- There must be enough space around the
machine for circulation to keep it permanently
unobstructed and to allow for safe movement of
the operator and the product being processed.
- We recommend installing the machine in a flat
location, free of oil, grease, holes, protected
from the sun and rain. Contact with water
increases the hazard of electrical shock.
- Never operate the machine inside closed
locations and without ventilation, the gases
released from the motor (diesel or gasoline) are
toxic and highly harmful to health.
- Be prepared in case of an accident. Keep a
first-aid kit on hand and easily accessible. Know
how to use it.
- Do not use this equipment for applications
which are not mentioned and considered
unacceptable in the manual and not authorized
by the manufacturer. Making adaptations or
using after-market parts can compromise the
operation, be dangerous to the safety of the
operator, and invalidate the guarantee.
- Follow the safety recommendations and pay
attention. Lack of attention while operating can
cause accidents.
DPM-500/1/2/4
7