Assembly As A Tractor Accessory - Nogueira DPM-1 Manual De Instrucciones

Assembly as a tractor accessory

The Nogueira factory also supplies a special accessory for installing as a tractor accessory.
BASIC INSTALLATION SEQUENCE
1- Complete set:
If the order is for the complete set, the machine will be shipped completely assembled from the factory.
In this case, the installation only includes the coupling to the tractor to the accessory, using the three-
point linkage from the hydraulic system, following that the respective installation of the driveshaft
(power take-off).
2- Separate orders:
If the accessory orders and the machine were ordered separately, the assembly of the set components
will be as follows:
a) Place the machine on the accessory;
b) Install the pulley on the machine;
c) Align the pulley on the machine to the accessory pulley, which is assembled on it;
d) Fasten the machine on the accessory;
e) Install the belts and the safety shield;
f) Stretch the belts correctly using the stretcher device;
g) Couple the assembly to the tractor, using the three-point linkage from the hydraulic system;
h) Finally the respective installation of the driveshaft (power take-off).
17
DPM-500/1/2/4