Maintenance - Nogueira DPM-1 Manual De Instrucciones

CUTTING ROOTS AND TUBERS
The product is placed in the intake chute and
comes out the lower chute.
1- Remove the smooth belt / sieve (2);
2- Place the inner cover (1);
3- Remove the moveable cover of the intake chute (3);
4- Remove the back closure (5);
5- Place the vacuum isolator (4) - if the machine is equipped with a cyclone.

Maintenance

Your DPM requires a minimum of maintenance in order to guarantee the maximum yield and
durability. Then, some essential routine procedures are indispensable:
- Keep the blades well-sharpened;
- Keep the counter-blade adjusted to the position of the blades;
- Lubricate the bearing periodically;
- Keep the belts stretched and replace them when they are worn or dried and cracked;
- Replace the set of blades or hammers, when they are damaged or worn;
- Never operate the machine when hammers or blades are missing.
Important!
Using after-market parts or accessories can cause accidents, damage to equipment, and decrease
the performance of its operation, as well as canceling the factory guarantee.
20
Turn off the machine before performing any type of adjustments, lubrication,
or any maintenance job.
When replacing screws and nut, always use the same factory specifications
as the original parts.
Pull all the shields back in place before turning on the machine.
Instructions Manual