Safety Precautions - Nogueira DPM-1 Manual De Instrucciones

Safety

SAFETY PRECAUTIONS

- Read the instruction manual before turning on
the machine. Pay close attention and respect all
the operating and safety recommendations
while operating. SHARE THIS INFORMATION
WITH OTHER USERS.
- Do not operate the machine while of after
drinking alcoholic beverages or medications
which affect your normal condition. Pay
attention to what you are doing and use good
sense. Any lack of attention while operating the
machine can result in a serious accident.
- Turn off the motor before adjusting, lubricating,
or performing any maintenance job on the
machine. Never try to perform any repairs when
machines are on. Always pay attention!
- Check to see if there are any tools or objects on
it, before turning on the machine.
- Look around the machine before turning it on.
Keep animal and spectators at a safe distance,
away from eating areas. Be especially careful of
children.
- Wear personal protective equipment - PPE
when operating the machine. Prolonged
exposure to noise can cause hearing damage or
loss. Wear hearing protectors and safety
glasses.
- Dress appropriately when operating the
machine. Tie back long hair and do not wear
clothing which is too loose. Remove rings,
chains, and other elements, which could get
stuck in the moving parts or mechanisms.
- Never try to open the machine when it is
operating.
- Never touch the pulleys or belts when the
machine is turned on. Keep your distance from
moving parts.
- Keep the safety adhesive labels in good
condition and legible. Replace them whenever
necessary.
6
Instructions Manual
- Keep all the protective shielding in its proper
places and do not operate the machine without it
being installed.
- People must not remain on any part of the
machine when it is operating.
- Turn off the motor and wait until all the parts are
completely motionless, whenever, it is
necessary to get on the machine to perform any
adjustment or repair.
- Never try to clean or remove remaining
products, straw etc., when the machine is turned
on. Turn off the motor and wait for all the parts to
stop moving before cleaning any part of the
machine.
- Never leave the machine operating and leave
the area. Always turn off the motor before
leaving the working area.
- Keep the surrounding areas free and
unobstructed, so the operator can move safety
around the machine and the product being
processed.
- Lower the machine completely to the ground
before performing any maintenance, lubrication,
or adjustments. If it is necessary work on the
machine when it is lifted hydraulically, make sure
it is supported securely. Hydraulic mechanisms
can move without any warning or due to leakage
and cause an accident.
- Never place the machine on cement blocks,
hollow bricks, or other supports which can be
crushed from the effects of loads during long
periods of time.
- Never work under a hoisted machine raised
just on a jack, always put a secure support under
it.
- If you notice any abnormal operation:
vibrations, strange noises etc., immediately turn
off the machine. Check and eliminate the cause,
before turning it on again.