NOTE
If the connection with a previously paired device doesn't take effect, it can be due to several reasons,
including a crash of the Bluetooth
several actions to apply:
Switch off and on the SHARE headset
•
Switch off and on the Bluetooth
•
Repeat the pairing procedure
•
Clear all pairing list on the device to be connected and repeat the pairing procedure
•
Clear All Pairing Devices
In power on and without any active phone call, press and hold both
button) together for 6 seconds; when the Red LED flashes 2 times release buttons and, after all paring
devices have been cleared, the SHARE headset will automatically power off.
Audio control
Volume Up or Down
In any audio active state, press and hold
audio source; press and hold
source. Release the button when the volume reaches the desired level. When the maximum or minimum
volume is reached, a "MAXIMUM VOLUME" or "MINIMUM VOLUME" message is prompted.
The volume of each audio source(two phones, two music, intercom, FM Radio, Aux in)can be
individually tuned, i.e. 7 different independent volume parameters can be used.
Volume Levels Automatic Save
All favorite volume levels for each audio source are saved by the SHARE headset at the power off, so at
next power on, the SHARE headset can automatically set the last user favorite volume level, without any
operation required by the user.
Automatic Noise Dependent Volume Control
During phone calls, intercom calls or GPS audio messages, if the wind noise or environment noise is very
high and the current volume is not at maximum level, the SHARE headset will automatically increase the
volume level according to the noise level, and when the noise disappears for a while, the volume
automatically returns to the original level.
Mono/Stereo
®
feature on the device to be connected. To solve this issue, there are
®
feature on the device to be connected
" (PLUS
button) to increase the volume of the corresponding
!
(MINUS button) to decrease the volume of the corresponding audio
- 9 -
!
(MFB button) and
AGV
!
(MINUS