Aux-In Operation - AGV SHARE Manual Del Usuario

AGV
Short press " (PLUS button) makes the FM radio automatically search for the next station on a higher
frequency, and a "dudu" tone means that the highest frequency station is reached. Short press ! (MINUS
button) to loop search-back.
For each new tuned FM station, SHARE headset prompts the FM frequency of the station and its RDS
name (if and when available).
Seek backward
Short click ! (MINUS button) makes the FM radio automatically search for the next at a lower frequency,
and a "dudu" tone means that the lowest frequency station is reached. Short click " (PLUS button) to
loop search-back.
For each new tuned FM station, SHARE headset prompts the FM frequency of the station and its RDS
name (if and when available).
Select channel
Double press the " (PLUS button) or ! (MINUS button) to select the next/previous channel.
After each channel change, the SHARE headset prompts the FM frequency of the station and its RDS
name (if and when available).
Station save and replace
Select the channel where the new radio station is to be stored. After seeking the desired station forward or
!
backward, within 15 seconds press and hold the (MFB button) for more than 1 second; the FM station
will be saved on the active channel and the message "FM STATION SAVED" confirms that the station
has been successfully saved.
Max 8 stations can be saved. After that, any further saving operation replaces the last saved station.
Mute FM audio
!
During FM receiving state, short press the (MFB button) to mute/unmute the FM radio audio.

AUX-in operation

Aux Audio Auto Switch
While there are no active phone calls or intercom talks, once the aux cable plug is inserted into the USB
jack, the SHARE headset will automatically switch to the external aux audio. After detaching the aux
cable from the SHARE headset USB connector, the audio will switch back to the mobile phone mode.
- 17 -