System Setup; Battery Charge - AGV SHARE Manual Del Usuario

Settings

System setup

Power on
In power off state, press
note, release the button, the blue indicator will flash to indicate power on successfully.
After power on, the device will auto report the last set audio mode (mono or stereo) and the current battery
level range (very low, low, half and full) by TTS.
If the SHARE has never been paired to any device or paired devices have been cleared, it will
automatically switch to pairing mode after powered on. If the SHARE finds already paired devices, it will
auto connect to the last 2 sets of paired and connected mobile phones or GPS devices. The message
"CONNECTED TO DEVICE", followed by the Bluetooth
successful connection.
NOTE
The message "CONNECTED TO DEVICE" (followed by the proper device name) may be repeated
twice, one for indicating the connection as telephone (HFP connection) and one for indicating the
connection as media player (A2DP connection).
After power on, wait at least 20 seconds before turning off the SHARE headset.
Power off
In power on state, press
"POWERING DOWN" prompt, LED indicator blinks red for a second and then it switches off to indicate
the headset has been powered off.
After power off, wait at least 30 seconds before restarting the SHARE headset.

Battery charge

In order to charge the battery inside the SHARE headset, connect the proper USB cable to the wall charger
or to a PC USB port.
LEDs will indicate when the charge phase has completed.
Reset
If the SHARE headset enters into a lock state or it needs to be reset due to a firmware upgrade procedure,
charge the system by inserting the USB cable and connecting it to the wall charger or to a USB port. The
first effect of this operation consists in SHARE headset reset.
#
(CTRL Button) and hold it for about 5 seconds, until you hear a "READY"
#
(CTRL Button) and hold it for about 6 seconds, until you hear the
®
registered name of the device, confirms the
- 5 -
AGV