AGV SHARE Manual Del Usuario página 8

NOTE
SHARE headset accesses to your phone book only for providing more comfortable services, like the
announcing of the caller name, or for activating a voice dial. No data will be transferred from your
mobile phone to SHARE headset.
Sometimes the access to the phone book is not completed and SHARE features based on it cannot work
well. Just in case, please switch off and on your SHARE headset or the Bluetooth
mobile phone.
Not all mobile phone allows a complete access to the phone book, so some SHARE headset features
based on it cannot properly work also after the above procedure.
The request to access the phone book is repeated for each connection of the mobile phone (not only at
the first pairing); to allow a proper functionality, such a request must be accepted before to start to use
the SHARE headset with the mobile phone.
You can now use SHARE to answer calls or to enjoy the music from mobile phone.
If no devices have been paired, the message "FAILED TO PAIR TO DEVICE" warns you.
To pair a second cell phone or GPS device just repeat all steps.
NOTE
The MP3 player included into the mobile phone doesn't require any specific pairing and connection to
the SHARE headset.
Anyway, for properly use such a MP3 player, also the "multimedia" connection mode has to be
enabled on Bluetooth
Pairing Intercom Headsets
Place two SHARE headsets in a visible area within 1 meter range.
Make sure SHARE headsets are in power off state.
For both SHARE headsets press and hold both
seconds, until you hear a "PLEASE PAIR DEVICE NOW, ENTER PIN CODE 0000" prompt.
NOTE
It is not necessary the
done also in sequence, but the seco none must be activated immidiately after the first one.
When the Blue LED and the Red LED alternately flash, release the button; the SHARE headset enters
in pairing state.
#
Short press (CTRL Button) on only one SHARE headset; it will prompt "PLEASE PAIR
INTERCOM NOW" and search for the other one in pairing state and try to pair with it.
NOTE
#
Do not short press
Within a few seconds, both headsets will turn off the Red light, and then slowly flash Blue. Pairing is
finished.
Pairing is a onetime process. Once the headsets are paired during this setup procedure, they will remain
paired and automatically recognize each other whenever they are within the proper range.
®
connection of the mobile phone.
!
(tasto CTRL) is pressed on both SHARE headsets at the same time; it can be
(CTRL Button) on both SHARE headsets
#
(CTRL Button) on the two headsets for about 8
- 7 -
AGV
®
channel on your