AGV SHARE Manual Del Usuario página 9

Super Priority Pairing
The SHARE headset can handle devices by assigning to one of them the "super priority" property to
override all other devices.
NOTE
Only one device can be defined as super priority device; the latest super priority paired device will
replace the previous one. Only a mobile phone or a GPS navigator (i.e. the HFP/HSP links) can be
assigned as super priority.
To assign the super priority property to a mobile phone or GPS navigator, follow the normal pairing
procedure (steps 1 to 4) and press the
paired.
Place the SHARE headset and the mobile phone (or GPS) in a visible area within 1 meter range.
Make sure the SHARE headset is in power off state.
#
Press and hold
NOW, ENTER PIN CODE 0000" prompt.
When the Blue LED and the Red LED alternately flash, release the button; the
in pairing state.
If you want to assign super priority property to the phone or to the GPS , just short press the
button) once at this time; it will prompt "PLEASE PAIR PRIORITY VOICE NOW" and then the LED
indicator flash pattern will be changed to red twice and blue twice quick flashing. Super priority
pairing is ready.
By following the mobile phone or GPS navigator instructions, turn on the Bluetooth
search for the headset devices.
From the devices found on your mobile phone, select the device named "Share Easy vx.xx", and try to
pair it by entering, if required on mobile phone, the pin code <0000>. Once paired successful, the LED
indicator will change from Blue/Red alternately to Blue flashing and a "di" tone indicates that the
SHARE headset has been connected with your mobile phone.
Stop the Pairing Procedure
To stop an initiated pairing procedure there are two possibilities:
Wait until the pairing procedure automatically timeouts
•
Switch off the SHARE headset by holding down the
•
Manual Connect to Last Connected Mobile Phone
SHARE headset automatically connects the last paired device when it has been detected.
If no mobile phone has not been automatically connected with the headset, a short press
will initiate connections to the last paired mobile phones.
If a mobile phone is already connected to SHARE, a long press of the
connections to the second to last paired mobile phone or GPS device.
!
(MFB button) before turning on Bluetooth
(CTRL Button) for about 8 seconds, until you hear a "PLEASE PAIR PHONE
#
(tasto CTRL)
!
- 8 -
AGV
®
on the device to be
SHARE
headset enters
!
(MFB
®
function, and
!
(MFB button)
(MFB button) will initiate