Usb Setup - AGV SHARE Manual Del Usuario

Connection to a PC
The SHARE headset can be connected to a Windows
Firmware upgrade
•
Device configuration of the following parameters:
•
Audio mono/stereo
o
VOX activation on/off
o
Auto/manual call answering and delay on automatic answering
o
FM channels stored stations
o
TTS language
o
Such operations can be performed by means of the proper AGV wizard software, available on the AGV
website (www.agv.com). This software must be installed on the PC before connecting it to the SHARE
headset.
To connect the SHARE headset to a PC, the proper USB cable must be used. Once this cable is inserted
into both the SHARE headset and PC USB port, the SHARE resets and switches to battery charge state.
To enable its communication with the wizard software, in power off state press and hold the
Button) for more than 20 seconds, until no more Red and Blue LED lights flash on the keypad. At that
time the SHARE headset can be detected by the wizard software.
NOTE
During the long pressing of the
flashes in different ways:
Red slow flashes: battery under charge
•
Blue slow flashes: device on
•
Red/Blue fast flashes: pairing mode
•
No flashes (or some Blue flashes): communication mode
•

USB setup

!
(CTRL Button) for enabling the communication, the keypad LED
®
PC for the following operations:
- 11 -
AGV
#
(CTRL