Steelcase Solo Sit-to-Stand Desk Instrucciones De Uso página 12

_______________________________________________________________
Changing the displayed unit – CM/INCH
 Simultaneously press and hold the buttons
"1", "2" and "Up" for three seconds; then
release the buttons.
The letter S and a number (e.g. S 7) are
=
indicated on the display.
 Press and hold the "Up" button until S 5 is
indicated on the display.
S 5 is displayed.
=
Press the "SAVE" button.

If the display was previously set to
=
centimetres (cm), it will now be switched
over to inches (inch) and vice versa.
Resetting to factory settings
This function can be used to reset the
system to the factory settings.
 Press and hold the buttons shown below for
3 sec.:
a Press buttons "1" and "2" and the
b "Up" button
The letter S and a number (e.g. S 4) are
=
shown on the display
 Press the "Down" button until S 0 is shown
on the display.
The display indicates S 0
=
Press the "SAVE" button.

The system has now been reset to the
=
factory settings.
12
Operating and adjusting
157238