Steelcase Solo Sit-to-Stand Desk Instrucciones De Uso página 14

_______________________________________________________________
Signal/Code
C2
C11
C13
C17
C19
C22
14
Message
Overcurrent with motor
Speed fails to be reached
DC undervoltage
Error with pairing
Too many or too few drive units are
connected
Overload of power supply
Errors and malfunctions
Required measure(s)
Release all buttons and wait 5 seconds.
Then try again.
Release all buttons and wait 5 seconds.
Then try again.
Release all buttons and wait 5 seconds.
Then try again.
Disconnect the power supply from the
mains connection.
Then disconnect the system from the
power supply. Re-connect the system
and use it as usual.
If this is not possible, perform a reset
to the factory settings.
Connect the correct number of drive
units (as specified under Setup).
Release all buttons and wait 5 seconds.
Then try again.
157238