Publicidad
Pièces de rechange
Pour les pièces de rechange, appeler le 1-800-4-RIDGID
S'il vous plaît fournir l'information suivante:
-Numéro du modèle
-Numéro de série (si applicable)
-Description de la pièce et son numéro sur la liste de pièces
N o
No de
Numéro
Ref.
catalogue
de pièce
L
1
L
2
L
3
I
4
I
5
I
6
I
7
8
25038
HL007600AV
G
*9
G
10
G
*11
G
*12
G
*13
G
14
15
25043
HL007500AV
N M
16
N M
17
M
18
M
19
M
20
M
21
22
25048
HL012000AV
23
†
24
†
25
25123
26
25053
HL009100AV
27
‡
28
‡
29
††
30
††
Description
Vis d'assemblage à six pans creux
M6-1.25 x 110 mm - tête cylindrique
Rondelle-frein M6
Rondelle plate M6
Vis autotaraudeuse à tête Phillips
3.5 mm DE x 12 mm
Pince de retenue du filtre à air
Filtre à aire
Écran du filtre à air
Tête du cylindre
Joint d'étanchéité de tête
Plaque porte-soupape
Joint de soupape centrale
Soupape
Joint d'étanchéité de cylindre
Goupille élastique XC5.4 mm
x 7 mm -plaque de soupape
Cylindre
Bague de compression
Bague de graissage
Piston
Axe de piston
Dispositif de retenue du piston
Tourillon de crosse
Assemblage de jauge d'huile avec
joint torique
Vis d'assemblage à six pans creux
M4-1.25 x 14 mm - couvercle avant
Couvercle avant du carter
HL012100AVVidange d'huile à joint torique -
M5-1.25 x 10 mm -
Joint d'étanchéité du couvercle
de carter
SHCS M8-1.25 x 25 mm
filet L.X. - excentrique
Contrepoids excentrique
Palier - carter de pompe
Joint d'huile 20 mm x 35 mm x
7 mm - carter
Fr 22
Safety Instructions
This manual contains information that is
very important to know and understand.
This information is provided for SAFETY
and to PREVENT EQUIPMENT PROB-
LEMS. To help recognize this informa-
tion, observe the following symbols.
Qte
Safety Signal Words
4
DANGER:
!
4
4
ardous situation which, if not avoided,
WILL result in death or serious injury.
1
1
1
1
Before Using the Air Compressor
1
1
Air compressors are utilized in a variety
2
of air system applications. Because air
1
compressors and other components
2
(material pump, spray gun, filters, lubri-
1
cations, hoses, etc.) used make up a
high pressure pumping system, the fol-
1
lowing safety precautions should be
1
observed at all times. Only persons well
2
acquainted with these rules of safe oper-
1
ation should be allowed to use the air
1
compressor.
1
1
WARNING:
!
1
All electrical work should be
done by a qualified (licensed or
1
certified) electrician. On a prop-
erly wired circuit, the black
4
1
wires supply a voltage potential
even when the unit is off.
1
1. Read instruction manuals for each
1
component carefully, before attempt-
ing to assemble, disassemble or
1
operate your particular system.
1
2. Wear safety glasses (meeting ANSI
1
Z87.1 or in Canada CSA Z94.3-99)
and use hearing protection when
1
operating the pump or unit. Everyday
glasses are not safety glasses.
WARNING:
!
ardous situation which, if not avoided,
COULD result in death or serious injury.
CAUTION:
!
ardous situation which, if not avoided,
MAY result in minor or moderate injury.
Danger indicates
an imminently haz-
NOTICE:
tion, that if not followed, may cause dam-
age to equipment.
3. Do not exceed pressure rating of any
component in system.
4. Protect material lines and air lines
from damage or puncture. Keep hose
and power cable away from sharp
objects, chemical spills, oil, solvents,
and wet floors.
5. Never point a spray gun at oneself or
any other person. Accidental dis-
charge may result in serious injury.
6. Check hoses for weak or worn condi-
tion, before each use, making certain
all connections are secure; do not
use if deficiency is found. Notify an
authorized service facility for exami-
nation or repair.
7. Release all pressures within system
slowly; dust and debris may be harmful.
WARNING:
!
Disconnect power and depres-
surize system before servicing
air compressor! (Turn pressure
regulator knob fully clockwise
after shutting off compressor.)
3
Warning indicates
a potentially haz-
Caution indicates a
potentially haz-
Notice indicates
important informa-
Publicidad
Capítulos
