Command Management From White Or Black Wire; Super-Sensitivity Obstacle Detection Management During Downwards Movement - FAAC TM2 ERY Manual De Usario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 78

COMMAND MANAGEMENT FROM WHITE OR BLACK WIRE

NB: The default function provided in the motors leaving the factory is UP-STOP-
DOWN-STOP for singular UP/DOWN button switch. (Not for the switch with two
independent UP-DOWN buttons!)
PROCEDURE TO CHANGE THE CONTROL MODE:
Tn: Already programmed remote control
+
B
C
Tn
The possible settings are 3 and are available in the following order:
- UP-STOP-DOWN-STOP (factory setting)
- UP-DOWN (for 2 independent buttons)
- UP-DOWN "Dead Man" (for 2 independent buttons)
To switch from one setting to the following, perform the sequence as many times
as necessary to reach the desired setting.
SUPER-SENSITIVITY OBSTACLE DETECTION MANAGEMENT
DURING DOWNWARDS MOVEMENT
- only for motors up to 25 Nm
Where required - for example for window screens or screen fabric with a tensioner
weight attached - it is possible to activate/deactivate a high level of obstacle de-
tection sensitivity during downwards movement.
ACTIVATING THE SUPER-SENSITIVITY FUNCTION
+
B
C
Tn
DEACTIVATING THE SUPER-SENSITIVITY FUNCTION
+
B
C
Tn
TM2 ERY
B
Tn
A
Tn
A
Tn
38
C
Tn (2 sec)
+
B
C
Tn (2 sec)
+
A
B
Tn (2 sec)
A4518_6G40_Rev.A

Publicidad

Tabla de contenido
loading

Tabla de contenido