Command Management From White Or Black Wire - FAAC TM2 ERX Manual De Instrucciones

COMMAND MANAGEMENT FROM WHITE OR BLACK WIRE

NB: The default function provided in the motors leaving the factory is UP-STOP-
DOWN-STOP for singular UP/DOWN button switch. (Not for the switch with two
independent UP-DOWN buttons!)
PROCEDURE TO CHANGE THE CONTROL MODE:
Tn: Already programmed remote control
+
B C
Tn
The possible settings are 3 and are available in the following order:
- UP-STOP-DOWN-STOP (factory setting)
- UP-DOWN (for 2 independent buttons)
- UP-DOWN "Dead Man" (for 2 independent buttons)
To switch from one setting to the following, perform the sequence as many times
as necessary to reach the desired setting.
Mode UP-STOP-DOWN-STOP:
B C
Mode UP-DOWN:
B C
Mode UP-DOWN "DEAD MAN":
B C
TM2 ERX
B
Tn
B
B
B
39
C
Tn (2 sec)
C
C
C
A4518_6G41_Rev.A