How To Prepare The Motor - FAAC TM2 ERY Manual De Usario

HOW TO PREPARE THE MOTOR

STOP RING NUT
1
2
3
NB: If you use tubes with a round form, the driving pulley must be fixed to the tube,
and the installation is to be paid by the person who installs the system. For other
tube sections the fitting is optional, but strongly recommended.
TM2 ERY
STOP RING NUT ADAPTOR
22
DRIVING PULLEY
1. Insert the adaptor in the nut mating
the groove with the reference notch and
push till they touch.
2. Fix the driving pulley on the motor pin
until the stop pin clicks.
3. Insert the motor fully in the rolling
tube.
A4518_6G40_Rev.A